Water damage restoration in Dallas-Fort Worth, TX is the process of removing standing water, drying framing and finishes to a measured moisture reading, and rebuilding what the water ruined, and the first 24-48 hours decide whether drywall dries out or grows mold. A burst supply line in a Plano two-story can push 400+ gallons through the ceiling before anyone notices, while a spring storm off the Trinity River can back water into slab homes across the metroplex.

A water damage restoration company in Dallas-Fort Worth is a service that extracts standing water, dries the structure to a documented moisture target, and repairs the affected drywall, flooring, and framing after a leak, burst pipe, or flood.
Every service reflects the same meticulous attention to detail, whether it's a single job or a larger water damage restoration project across Dallas-Fort Worth.

Truck-mounted and portable extractors pull standing water from floors, carpet, and pad, moving up to hundreds of gallons per hour. This is the first step on any loss and is set up the same visit, the faster water leaves, the less it wicks into baseboards and subfloor. Typical single-room extraction takes 1-2 hours before drying equipment goes in, and carpet that is extracted and floated within the first day is often saved rather than replaced. Weighted extraction wands press water out of pad without pulling the whole carpet up, which matters in furnished rooms where a full tear-out would mean moving everything out first.
Get a quote →
Air movers and commercial dehumidifiers dry framing, subfloor, and cavities to a documented moisture reading, usually over 3-5 days. Crews place roughly one air mover per 10-16 linear feet of wet wall and log daily readings so drywall is only reopened or rebuilt once it is genuinely dry. This service prevents the hidden secondary damage that shows up as warped floors weeks later. A single low-grain-refrigerant dehumidifier can pull 15-30 gallons of water from the air per day, which is why closing up a room with a household fan instead almost never dries the cavity behind the baseboard. Moisture readings are taken with a pin meter in wood and a non-invasive scanner in finished walls so the paperwork shows exactly when each surface reached target.
Get a quote →
DFW winters bring hard freezes that split copper and PEX lines, and a single burst supply line can release 400+ gallons before the main is shut off. This service covers extraction from the affected floors, opening wet wall cavities where the line runs, and drying the framing behind the break. Coordination with a plumber for the actual pipe repair is arranged so drying does not start over a still-leaking line. Attic and exterior-wall runs are the usual failure points in a Texas freeze because they sit outside the heated envelope, and water from an attic break travels down through the ceiling and into two floors of wall before it surfaces, so the wet map is often larger than the stain.
Get a quote →
Water from a second-floor bathroom or a roof leak collects above the ceiling and stains, sags, or drops sheetrock. This service maps the wet area with a moisture meter, removes saturated ceiling drywall and insulation, dries the joists, and rebuilds. Catching an overhead leak in the first day often saves the light fixtures and the ceiling above adjacent rooms. Wet blown-in insulation loses its R-value and holds water against the drywall, so it is removed and replaced rather than dried in place, and the joist bays are dried with directed air before new insulation goes back up.
Get a quote →
Spring storms and flash flooding off the Trinity River and its tributaries push ground water into garages, slab homes, and low-lying rooms across the metroplex. Flood water is treated as contaminated, so this service includes water removal, muck-out of porous materials, antimicrobial treatment, and structural drying. Documentation is built for the insurance claim as the work proceeds. Ground-level flood water usually enters at the slab line, so the scope centers on the bottom of the walls, the subfloor, and any built-in cabinetry that wicked water up its base, and the mud and silt a creek leaves behind are removed before drying begins so nothing organic stays trapped in the cavity.
Get a quote →
A backed-up sewer line or toilet overflow is Category 3 black water carrying bacteria, and every porous material it touched, carpet, pad, drywall bottom, cabinet toe-kicks, is removed rather than dried. This service includes removal, disinfection of the exposed structure, and controlled drying under containment. Safe handling protocols follow IICRC water-damage guidelines. Crews work in containment with negative air so contaminated aerosols do not spread to dry rooms, hard non-porous surfaces are cleaned and disinfected rather than discarded, and the exposed framing is treated with an antimicrobial before any rebuild is scheduled.
Get a quote →
Wet drywall and framing left more than 48 hours grow visible mold, and this service removes the affected material under containment, HEPA-vacuums the area, and treats framing with antimicrobial before rebuild. It pairs directly with drying so the moisture source is confirmed gone first. Air scrubbers run during removal to keep spores from spreading through the HVAC. Containment is sealed with poly sheeting and the work area is held under negative pressure so the removal does not seed the rest of the house, and the supply and return registers in the affected room are covered while the scrubbers run.
Get a quote →
When a room has to be fully torn out, salvageable furniture, boxed belongings, and electronics are inventoried, moved out of the wet zone, and dried or stored while the structure is worked. This keeps porous contents from acting as a moisture source inside a closed room and gives the crew clear floor space to open walls and set equipment. Photographed inventory supports the personal-property side of an insurance claim, and paper documents or photos caught early are candidates for controlled drying rather than loss.
Get a quote →You get a firm, itemized quote for your water damage restoration before any work begins, no surprises, no pressure.
Careful prep, tidy work, and a full cleanup when we are done. We treat your home and belongings like our own.
The same trusted, background-checked team from the first call to the final check.
If you have clean water from a supply line or overflowed tub and caught it inside a day, choose an emergency extraction-and-dry package, crews pull the water, set air movers, and often save the drywall and hardwood without demolition. If the water sat 48 hours or came from a dishwasher, washer, or ground-level seepage, choose the full restoration path that includes controlled demolition of soaked drywall and insulation, because saturated gypsum wicks moisture and grows mold within two to three days. If the water is Category 3, a sewage backup or river flooding off the Trinity, choose the sanitation-plus-rebuild scope, since that water carries bacteria and every porous material it touched must be removed and the cavity antimicrobial-treated.
For a slab-on-grade home in Frisco or West Dallas where water crept in at floor level, the drying scope focuses on the subfloor, tack strip, and the bottom 12-16 inches of wall rather than the whole ceiling assembly; for a two-story where a second-floor line failed, drying often has to open both the ceiling below and the wall the water tracked down. The trade-off is cost and downtime versus risk: aggressive drying-in-place is cheaper and faster but only works when water is clean and fresh, while full tear-out costs more and adds rebuild days but is the only safe route once water is contaminated or has been sitting.
Every project gets a firm, written price after a free on-site visit. Ranges below for orientation.
Tell us about your water damage restoration job and we'll send a clear, written quote, usually the same day. Or just call and talk to a real Dallas-Fort Worth pro.
(817) 889-8466
Dallas-Fort Worth sits on expansive clay soil that swells and shrinks with the region's wet-dry swings, which stresses slab foundations and lets ground water find its way into slab-on-grade homes during the spring storm season, a big share of local losses are ground-level, not roof leaks. Older bungalows in Lakewood and Fort Worth's Fairmount district often run galvanized or original copper supply lines that split in a hard freeze, while newer builds in Frisco and Plano tend to fail at PEX fittings and second-floor laundry connections. Flooding off the Trinity River corridor and its creeks routinely backs water into low-lying garages and additions in West Dallas and parts of Irving, so flood-recovery scopes here treat that water as contaminated by default. The February 2021 statewide freeze is a reference point for how many pipes a single sustained hard freeze can break across the metroplex at once, and homes without insulated attic runs or a known main shut-off remain the most exposed when temperatures drop into the teens. Homes near creeks feeding the Trinity, including White Rock Creek through East Dallas and the branches around Arlington, see the fastest ground-level rise in a flash-flood warning, which is why keeping valuables off the garage floor ahead of a spring storm line matters in low-lying additions.
Free estimates for Dallas-Fort Worth & the surrounding area.